Great Planes F6F Hellcat EP Park Flyer ARF - GPMA1159 User Manual

Page 11

❏

1. Attach the “Hook,” or rough side, of the supplied hook

and loop tape to the battery tray inside the radio
compartment. Attach the “loop,” or soft side, of the hook and
loop tape to the underside of the battery. Install the battery
as shown.

❏

2. Using leftover hook and loop tape, or double sided

servo tape, mount the receiver in the radio compartment.

❏

3. Connect the electronic speed control (ESC) and

elevator servo to the receiver.

❏

4. Connect a 6" [153mm] servo extension to the aileron

channel on your receiver. Route the extension below the
radio tray and out the middle hole in the leading edge of the
wing saddle as shown in the photo.

❏

5. Drill a 1/16" [1.6mm] hole in the side of the fuse near

the receiver. The exact location is not important. Route the
antenna out of this hole and along the fuse side. Make sure
you have a strain relief on the antenna where it exits the
fuselage to keep the pressure off of the solder joints in the
receiver. Secure the antenna to the fuselage with clear tape.

❏

6. Reinstall the battery hatch.

Radio and Battery Installation