Great Planes Syncro EDF - GPMA1581 - Manual (Page 9)

9
❏
6. Test-fi t, but do not glue in the spar covers. Once you see
that the spar and spar covers fi t well, remove and apply glue all
the way around the spar—an epoxy brush is great for spreading
the glue. Place the spar in the wing. Coat the channel and the
spar covers with glue, then fi t them into the wing.
❏
7. Wipe away excess glue with paper towels and make
certain the spar covers remain in position until the glue
dries—they shouldn’t require clamps or tape, but just
monitor the spar covers for a few minutes pressing them
back down into the wing if necessary. After a few minutes the
glue should set well enough to hold them into position until
you can handle the wing after the glue has completely dried.
SPORT WING:
❏
1. Connect the short Y-connector to the aileron servo wires.
Use a drop of glue to hold the connectors in the channel so
they won’t move around and interfere with the fi t of the spar
covers when gluing them in.
❏
2. Test fi t the spar covers—they should fi t all the way down
until they are fl ush and even with the bottom of the wing.
❏
3. Remove the spar covers. Apply glue to one of the spar
covers and in the corresponding channel in the wing—make
especially sure that you get glue on the spar and in the
groove in the spar cover for the spar. Hint: An epoxy brush
will make it easier to evenly distribute the glue.
4. Insert the spar cover and wipe away excess glue with
paper towels. Glue in the other spar cover the same way.
Wipe away excess glue with paper towels and make certain
the spar covers remain in position until the glue dries—they
shouldn’t require clamps or tape, but just monitor the spar
covers for a few minutes pressing them back down into the
wing if necessary. After a few minutes the glue should set
well enough to hold them into position until you can handle
the wing after the glue has completely dried.