Great Planes F-86 Sabre Micro EDF RTF - GPMA1770 - Manual (Page 6)

6
PREPARE THE TTX402 TRANSMITTER
For more information on the Tactic Radio System included
with the F-86 Sabre visit tacticrc.com
Leave the TTX402
unpowered.
Push in and slide to
remove the battery door.
Install (5)
“AA” batteries.
Replace the
battery door.
INSTALL THE LANDING GEAR
The landing gear is required for takeoffs and landings on
smooth, paved surfaces such as your fl ying fi eld runway or
a parking lot. The gear should be left off if you plan to hand
launch the plane and land it on grass.
Carefully insert the main wire landing gear into the plastic
gear mounts in the orientation shown.
Slide the gear into the mounts until the small bent end of the
gear base contacts the tab on the gear mounts.
Install the nose gear wire in the same manner.
When removing the gear, slide the wire straight out of the gear
mounts until free. Pull the gear out at the base of the wire and
work slowly to avoid damaging the plane.
POWER THE TTX402 AND
CENTER THE TRIMS
TRIM ADJUSTMENT
Full extent............. Centered ........... Full extent
Constant «beep» .....Single «beep» ..... Constant «beep»
Illuminated red light indicates the
TTX402 is powered and transmitting.
Center the rudder, aileron,
and elevator trims.
Keep the left stick
(throttle control) in the
minimum throttle
position during setup.
Power switch “ON”.