Countax A50 - Manual (Page 6)

Page 6 Page 23
Wiring Diagram Controls - Levers
IMPORTANT - READ SAFETY INSTRUCTIONS BEFORE OPERATING THIS MACHINE MULCHING
For Best results;
- Do not reduce the height of the grass by more than 1/3 in a single pass
- Mow often - short clippings of 25mm (1") or less decompose more quickly
- If possible, avoid cutting in the wet
- Always cut with the engine at full running speed
- If an unsightly residue is present - increase cutting height
- Vary mowing pattern from cut to cut
- Always keep the underside of the deck clean to permit good grass flow
- Always ensure that blades are sharp and in good condition
VIBRATION TESTED TO THE FOLLOWING STANDARDS BS 6842:1987, DD ENV 25349:1993, SI 1992:3073, BS6841:1987
15 MAX O 15 MAX
EXERCISE CAUTION WHEN CUTTING ON SLOPES
PTO
O
POWER-TAKEOFF (PTO)
Push the lever down and to the left to engage the pto, to disengage
push the lever down and lift to the right.
ELECTRIC LIFTS
The cutting height is adjusted by rotating the ‘dial-a-height’ switch
anti-clockwise to lower the deck and clockwise to raise the deck.
The indicated heights (1-lowest to 10-highest) are shown for
guidance purposes only. To get the best from this refinement use it
to continuously adjust cutting height to suit ground and grass
conditions. Do not make downward adjustments on the move until
you are familiar with this height control, to avoid scalping.
Raising the Auxiliary Lift is achieved by pressing the switch (B) to
the left of the dashboard – UP to raise, DOWN to lower (fig 3).
PGC NET EMPTY SWITCH
A third switch is fitted to those Tractors with a Powered Grass
Collector. This switch empties the collector net via an electric
actuator mechanism that lifts the grass box and pushes out the
bottom pan, fully emptying the collector contents. Press the switch
UP to open and DOWN to close the net (fig 5).
SEAT ADJUSTMENT
The seat on the A20/50 is adjustable forwards and rearwards to suit
the operator. Simply lift the seat latch at the front of the seat (fig 4)
and slide the seat forwards or backwards to suit. Always ensure the
seat is latched back into position before driving off.
(A) Dial-
a-height
Switch
(B)Auxiliary
Lift Switch
fig 1
fig 2
fig 3
fig 4
O fig 5
PGC Net Empty
Switch
Press UP to empty
and DOWN to Close
Electric Clutc Electric Clutch
Switc Switch
Light Switc Light Switch
Loom Loom
Connector Connector
Red Red
Loom Loom
Connector Connector
Light Loom Light Loom
Connector Connector
Brake Switc Brake Switch
Fuel Solenoid Fuel Solenoid
Soc Socket ket
Regulator Regulator Star Starter ter
Motor Motor
Seat Switc Seat Switch
P.T.O.
Soc Socket ket
(Red / Blue) (Red / Blue)
Ignition Cut Out Ignition Cut Out
(Bolt on Connector)
(Bolt on Connector)
Ignition Cut Out Ignition Cut Out
(Female Spade Connector) (Female Spade Connector)
Connector For H.E. Connector For H.E.
Ear Earth Connector th Connector
For H.E. For H.E.
Ignition Ignition
Switc Switch
15A 15A 20A 20A 20A 20A
Solenoid Solenoid
Electric Clutc Electric Clutch
Batter Battery
Engine Engine
1
2
4
5
TRA TRACT CTOR OR WIRING DIA WIRING DIAGRAM GRAM
Ignition Soc Ignition Socket ket
10A 10A
10A 10A
12 Red / 12 Red / Yellow w
1 White White
2 Red / Blue 2 Red / Blue
3 Br
3 Brown wn
4 Gre 4 Grey
5 Red / Blue
6 White / Red White / Red
7 Black
8 Purple
9 Yellow
10 Green 10 Green
11 Orang
11 Orange
13 Blue 13 Blue
Orange
Purple
Black Red
Red /
Blue
+ -
3 6