GME TX680 - Manual (Page 8)

Page 8 INSTRUCTION MANUAL TX680
POWERING THE RADIO
Your TX680 is powered by a 7.4 Volt
1000 mAh Li-Ion battery pack. When the
battery pack is new, it should be fully
charged before being used for the first
time. If left unused, your TX680’s battery
pack will discharge itself within a few
months. If you have not used your TX680
for some time, you will need to recharge
the battery pack before use.
WARNING: Use only the approved GME
charger. The use of other types may be
dangerous and will void the warranty.
Fitting the Battery Pack
To fit the battery pack:
1. Locate the bottom of the battery pack
into the two slots in the base of the
radio frame.
2. Press the top of the battery pack in to
place against the radio until it ‘clicks’.
To Remove the Battery Pack
1. Slide the battery retaining clip
downward while pulling the top of the
battery away from the radio.
2. Lift the battery pack upward to clear
the slots at the bottom of the radio.
Charging the Battery Pack
Your TX680 is supplied with an AC
adaptor and a Semi-quick charger. The
charger will charge a fully discharged
1000 mAh battery pack to full capacity in
around 3-4 hours.
1. Plug the charger into a standard 240
Volt AC outlet.
2. Plug the lead from the charger into the
charging cradle.
3. Place the TX680 into the cradle. The
Red LED will light to indicate the
battery is charging.
4. When the battery has charged, the LED
will change to Green.
To Remove Battery Pack
Swing
Away
Slide
Down
To Refit Battery Pack
Press Press