GME TX680 - Manual (Page 10)

Page 10 INSTRUCTION MANUAL TX680
GENERAL OPERATION
Power on/oFF
Rotate the Volume control clockwise past
the ‘click’ to turn the radio on. Rotate the
control counter-clockwise past the click to
turn the radio off again.
AdjUsting tHe VolUme
With the unit powered on, rotate the
Volume control clockwise to increase the
volume and counter-clockwise to decrease
the volume.
disPlAy ligHting
The LCD backlighting activates
automatically whenever a key is pressed
and turns off automatically after about 5
seconds.
reCeiVing signAls
While the TX680 is not receiving signals,
it will remain in the Standby mode to
conserve battery power. When a signal is
received, the LED indicator on the upper
edge of the radio will light Green and the
icon will appear on the display. Adjust
the volume control for a comfortable
listening level.
If the incoming signal is encoded with a
CTCSS tone that matches the one set in
your radio, the LED indicator will light
Orange and you will be able to hear the
signal in the speaker.
If the LED indicator lights Green and
the icon appears but you cannot hear
the signal, it is likely that your radio has
CTCSS enabled and the incoming signal is
not using your selected CTCSS tone (see
Mode Settings for more details on CTCSS
settings).
If no further signals are received, the unit
will return to standby mode.
trAnsmitting
To transmit, press and hold the Push-To-
Talk (PTT) switch. The other radio you
are talking to must be set to the same
channel (and CTCSS code if applicable).
Hold the TX680 approximately 5 to 8 cms
from your face with the antenna vertical
and speak into the built-in microphone.
While the PTT switch is pressed, the LED
indicator on the upper edge of the radio
will light RED and the icon will appear
on the LCD.
When you have finished speaking, release
the PTT switch to receive incoming signals
(it is not possible to transmit and receive
at the same time). If no further signals are
received, the unit will revert to standby
mode.
TIP: The PTT switch can also be used to
to transmit a Call Alarm melody. When
the Call Alarm melody is enabled (see
Mode settings for more details on the Call
Alarm settings), pressing the PTT switch
twice quickly will call another party on
the same channel and play the Call Alarm
melody in their radio’s speaker. When this
happens, the icon will appear and the
LED indicator will light RED for about 5