GME TX630 - Manual (Page 9)

TX630 Instruction Manual Page 9
to set radio for VoX operation
From the Standby mode:
1. Press the moDe key THREE times to
select the VOX setting mode. ‘VOX’ will
flash on the display.
. Press the or keys to select
the sensitivity from 1 (minimum) to 7
(maximum). The minimum setting
requires a louder voice to activate the
VOX. The maximum setting will activate
the VOX with a much softer voice.
3. To disable the VOX completely, set the
VOX sensitivity to of.
4. Press and hold the moDe key (or press
the Ptt key momentarily) to confirm
and store your selection. When the ‘VOX’
is enabled, ‘VOX’ is visible on the display.
4. Dual Watch Settings
The Dual Watch mode lets you to monitor
two channels at the same time. While in
dual watch mode, the unit will monitor both
the currently selected channel and a second
dual watch channel.
to set the Dual Watch mode
From the Standby mode:
1. Press the moDe key FOUR times to
select the Dual Watch setting mode.
The icon will flash on the display.
. Press the or keys to select the
Dual Watch channel number (1 – 40).
To disable the Dual Watch Mode
altogether select of.
3. Press and hold the moDe key (or press
the Ptt key momentarily) to confirm and
store your Dual Watch channel selection.
will be displayed at the top of the
LCD and the display will now alternate
between the currently selected channel
and the dual watch channel.
To EXIT the Dual Watch mode, turn the
radio off, or momentarily press the SCan
key. This is equivalent to setting the DW
mode to of.
Dual Watch operation
• If a signal is received on the Dual Watch
channel, the radio will pause on that
channel for as long as it remains busy,
then resume the Dual Watch 5 seconds
after the last transmission has ceased.
• If you wish to talk on the busy channel,
press the Ptt switch while the radio is
locked onto that channel then talk in the
usual way.
• If you wish to talk on the selected
channel, press the Ptt switch while no
signals are being received. The radio will
switch to the selected channel.
5. roger Beep tone Settings
The Roger Beep is a tone which is
automatically transmitted whenever the
Ptt switch is released. This tone alerts
the receiving party that your transmission
has ended.
to enable or disable
the roger Beep tone
From the Standby mode:
1. Press the moDe key FIVE times to select
the Roger Beep setting mode. ‘Rb’ will be
displayed along with a flashing .
. Press the or keys to set the tone
to on or of as desired.
3. Press and hold the moDe key (or press
the Ptt key momentarily) to confirm
and store your selection. If the Roger
Beep function is on, will remain
steady on the display.
6. Button Beep tone Settings
The Button beep tone feature allows the
transceiver to sound a confirmation tone
whenever the SQL, SCan, moDe, ,
or DUP keys are pressed.