GME TX670TP - Manual (Page 11)

TX670TP INSTRUCTION MANUAL PAGE 11
5. sqUelCH settings
The ‘Squelch’ mode lets you adjust the receiving sensitivity. The
higher the Squelch level is set, the stronger the signal needs to be
for it to be received by the radios.
To Set the ‘Squelch’ Mode
1. Press the MODE key FIVE (5) times to select the Squelch setting
mode, ‘ ’ will be displayed.
2. Press the or keys to select the Squelch level from 01
(lowest) to 03 (highest) setting.
3. Press the MODE or PTT key momentarily to confirm and store
your Squelch mode selection.
6. roger BeeP tone seleCtion
The Roger Beep is a tone which is automatically transmitted
whenever the PTT switch is released. This tone alerts the receiving
party that your transmission has ended.
To Enable or Disable the Roger Beep Tone
From the ‘Standby’ mode:
1. Press the MODE key SIX (6) times to select the Roger Beep
setting mode. ‘Rb’ will be displayed along with a flashing .
2. Press the or keys to set the beep to ‘On‘ or ‘oF‘ as desired.
3. Press the MODE or PTT key momentarily to confirm and store
your selection. If the Roger Beep function is on, the icon will
remain steady on the display.
7. BUtton BeeP tone seleCtion
The Button Beep tone feature allows the radios to sound a
confirmation tone whenever the MON, SCAN, MODE, or
keys are pressed.
To Turn the Button Beep Tones On or Off
From the ‘Standby’ mode:
1. Press the MODE key SEVEN (7) times to select the Button Beep
setting mode. ‘bP’ will be displayed along with a flashing
icon.
2. Press the or keys to set the beep to ‘On‘ or ‘oF‘ as desired.
3. Press the MODE or PTT key momentarily to confirm and store
your selection. If the Button Beep function is on, the icon
will remain steady on the display and a beep will be heard in
response to key activation.
8. CAll AlArm seleCtion
The TX670 provides 5 user selectable call alarm melodies to alert
other users to your incoming call. When enabled, the melody can be
transmitted to another user where it will be heard in the speaker of
the receiving radio.
To Select our Favourite Call Alarm Melody
From the ‘Standby’ mode:
1. Press the MODE key EIGHT (8) times to select the Call Alarm
setting mode. ‘C’ will be displayed.
2. Press the or keys to preview (listen) to the 5 available
call melodies.
3. To turn the call melodies off, select ‘oF‘.
4. Press the MODE or PTT key momentarily to confirm and store
your selection.
To Send the Call Alarm Melody
Press the PTT switch twice quickly. The LED indicator will light red
for a few seconds as the melody is sent. The melody will be heard in
the speaker of the receiving radio.