GME GX800W User Manual

Page 11

G X 8 0 0

I N S T R U C T I O N M A N UA L

1 1

3 Press the

keys to select the value of the

fl ashing digit (0 – 9).

4. Press the

key to confi rm the selection and move

to the next digit.

5. Repeat steps 3 & 4 to enter the entire 9 digit ATIS ID.

6. When the last digit is entered you will be prompted

to enter the ATIS ID again (this is to avoid entering an
invalid entry).

7. After entering the correct ATIS ID for the second time,

the ATIS ID will fl ash then the radio will revert to normal
operation.

NOTE:

If the second ATIS entry doesn’t match the fi rst, the

operation will be cancelled and you will need to start again.

CHARGING THE BATTERY

The battery is a built-in design and is not user serviceable. If
the battery requires replacing, the radio should be returned
to GME for service to ensure the waterproof integrity of the
radio is maintained.

To Charge the Battery
Pull the connector cap on the top panel (between the Volume
control and the antenna) to expose the charging socket. Plug
the supplied AC adaptor into the 240V power then connect
the adaptor’s charger plug into the socket on the top of
the radio.

While the charger is connected the display will show the
battery charging state by animating the battery icon.

IMPORTANT:

The connector used to charge the GX800 is a

Mini USB type charging at 8V (instead of the customary 5V
normally associated with this connector).

For this reason,

• Do not connect your GX800 charger to other mini USB

devices as damage may occur to your device.

• Do not remove the warning label ﬁ tted to the charging

lead on the GX800 charger.

Eg. for ATIS ID 342985532

DIGIT

POSITION 1

DIGIT

VALUE 3

2. PLUG SUPPLIED

AC CHARGER
INTO SOCKET

1. PULL CONNECTOR

CAP AWAY FROM
TOP PANEL

LIFT CAP