GME MT600GAUS - Manual (Page 10)

1 0 I N S T R U C T I O N M A N UA L M T 6 0 0 / G
IN THE EVENT OF ACCIDENTAL ACTIVATION
If you suspect that an EPIRB has been activated inadvertently, you MUST turn it off
and report it immediately to your National Authority‘s Rescue Co-ordination Centre to
prevent an unnecessary search.
If at sea, call your local VHF coast station or Rescue Co-ordination Centre.
In international waters contact a Maritime Rescue Co-ordination Centre or Coast Radio
Station (CRS) by any available means.
When reporting you should include the following:
1. Your EPIRB’s 15 character Unique Identifier Number (UIN) which is marked on
the unit body.
2. Date, time and duration of activation
3. Cause of activation
4. Location at time of activation
Search and Rescue authorities will not penalize an EPIRB owner or operator in cases
of genuine accidental activation.
BATTERIES AND MAINTENANCE
The MT600/MT600G is fitted with the very latest in high capacity lithium battery
technology. These batteries are able to operate within a temperature range of -20°C
to +55°C.
The full operational capability of your beacon may not be available if the batteries
fitted have exceeded their replacement date, as shown on the body of the unit. Prior
to reaching this date, make arrangements to have your EPIRB returned for service.
If the red LED lights when the TEST button is pressed and the EPIRB fails to start, the
battery voltage has been depleted.
NOTE: The replacement of batteries due to expiry or usage is not covered by the
product‘s warranty. EPIRB maintenance operations, including battery replacement,
require that the beacon be returned to a manufacturer approved service facility.
Although the MT600/MT600G is otherwise maintenance free, routinely following
these few simple steps will help ensure that your beacon will be operationally ready
if called upon.
1. Test the EPIRB at the recommended interval (refer to ‘Testing the EPIRB’ below)
2. Confirm the SAFETY SEAL has not been broken
3. Check that the batteries have not passed their replacement date
4. Inspect the MT600/MT600G and bracket for damage or deterioration
5. Keep the unit clean by wiping over with a damp cloth (warm water and mild
detergent are suitable) – then dry.
6. Verify that the unit releases correctly from the bracket and is securely retained
when returned to it.
If there is any doubt as to the EPIRB’s serviceability, immediately contact your
authorised dealer or service centre for advice.