GME MT406GAUS - Manual (Page 10)

PAGE 10 instruction mAnuAl 406G EPirB
Batteries and maintenance
the mt406G is fitted with the very latest in high capacity lithium
battery technology . these batteries are able to operate within a
temperature range of -20°c to +55°c .
the full operational capability of your beacon may not be available if
the batteries fitted have exceeded their replacement date, as shown on
the body of the unit . Prior to reaching this date, make arrangements to
have your EPirB returned for service .
NotE : The replacement of batteries due to expiry or usage is not
covered by the product‘s warranty. EPIRB maintenance operations,
including battery replacement, require that the beacon be returned
to a manufacturer approved service facility.
Although the mt406G is otherwise maintenance free, routinely
following these few simple steps will help ensure that your beacon will
be operationally ready if called upon:
1. test the EPirB at the recommended interval .
2. confirm the sAFEty sEAl has not been broken .
3. check that the batteries have not passed their replacement date .
4. inspect the mt406G and bracket for damage or deterioration .
5. keep the unit clean by wiping over with a damp cloth (warm water
and mild detergent are suitable), then dry .
6. Verify that the unit releases correctly from the bracket and is
securely retained when returned to it .
if there is any doubt as to the products’ serviceability, immediately
contact your authorised dealer or service centre for advice .
NotE: Some installations may be covered by state, national or
international carriage requirements. Such legislation may impose
additional inspection and maintenance requirements beyond those
listed above. Contact the relevant authority for further information.
safety seal
the safety seal which covers the tab behind the ‘
ON’ slider is designed
to tear if the unit is switched on . A safety seal that is not broken serves
to indicate that the beacon has never been manually activated .
nEVEr remove or break the seal unless deploying the EPirB in an
emergency .
if the beacon has been activated for any length of time, the batteries
can no longer be guaranteed to have the capacity to operate for the
minimum 48 hour period and therefore must be replaced .
testing the EpIrB
it is recommended that you test the mt406G at regular intervals
(approximately monthly) to ensure it is fully functional . you should also
test the EPirB prior to an extended journey .
Do Not over test – testing consumes some battery power.