GMC 2007 Canyon - Manual (Page 219)

Press the INFO button to display additional text
information related to the current FM-RDS or XM™
station. A choice of additional information such
as: Channel, Song, Artist, and PTY (program type)
may appear. Continue pressing the information
button to highlight the desired label, and the
information about that label displays.
When information is not available, No Info displays.
To change the default on the display, press the
INFO knob until you see the desired display, then
press and hold the knob until you hear a beep. The
selected display becomes the default.
AUTO VOL (Automatic Volume): With automatic
volume, the audio system adjusts automatically to
make up for road and wind noise as you drive by
increasing the volume as vehicle speed increases.
Set the volume at the desired level. Press this
button to select MIN (minimum), MED (medium),
or MAX. AUTO VOL (maximum automatic volume)
appears on the display. Each higher setting
provides more volume compensation at faster
vehicle speeds. To turn automatic volume off,
press this button until AUTO VOL OFF appears
on the display.
Finding a Station
BAND: Press this button to switch between FM1,
FM2, AM, or XM1 or XM2 (if equipped). The
display shows the selection.
o
TUNE
p
: Turn this knob to select radio
stations.
© SEEK ¨ : Press either the SEEK or the TYPE
arrows to go to the next or to the previous
station and stay there.
The radio only seeks stations with a strong signal
that are in the selected band.
© SCAN ¨ : Press and hold either the SCAN or
the TYPE arrows for two seconds until SCN
appears on the display and you hear a beep. The
radio goes to a station, plays for a few seconds,
then goes to the next station. Press either the
SCAN or the TYPE arrows again to stop scanning.
219