GIN Mirage - Manual (Page 24)

24
Transport and Storage
Moisture is the worst enemy for your glider, adversely affecting the ageing of fabric, lines and
reinforcements. The Mirage should therefore be kept dry and cool. Do not pack the glider away
for a prolonged period if it is damp, sandy, salty, or if other objects have entered the cells.
Always allow it to dry naturally before storage, in a cool, dry room. Leave the rucksack zip open
whenever possible to allow residual moisture to evaporate, and do not transport or store the
glider in the proximity of chemicals such as gasoline, paints or other solvents.
Cleaning
Use only lukewarm water and a soft cloth to clean your wing. Never use any abrasive materials
or detergents. Only clean the wing if it is absolutely necessary e.g. after a landing in salt water.
Inspections
GIN Gliders recommend that the Mirage is inspected by an authorized Gin agent. The first
inspection shall take place 30 months after the first flight or after 200 hours, whichever
happens sooner. Consecutive inspections shall take place every 200 hours flying time or every
24 months, whichever happens sooner.
A full inspection will give you peace of mind and extend your glider's lifetime. Additional
inspections should be performed by a qualified person following a crash or violent landing on
the leading edge, or if you note a deterioration of performance or behaviour.
You should also check for any damage to your lines, wing, and karabiners before each flight.
Repairs
Very small holes in the wing can be repaired with the sticky back tape provided with your glider.
Ideally, damaged lines should be replaced by your GIN dealer. Before fitting a replacement line,
check it for length against its counterpart on the other side of the wing. When a line has been
replaced, always inflate the glider on flat ground to check that everything is in order before
flying.
Major repairs, such as replacing panels, should only be carried out by the distributor or the
manufacturer.
Environmentally friendly disposal
GIN paragliders are manufactured with non-toxic materials that have been assessed for their
environmental impact. When your Vantage has reached the end of its life after a number of
years, please take care to dispose of it in an environmentally friendly manner. Please check
with local authorities regarding the current regulations and disposal facilities in your area.
Act responsibly and help preserve your flying sites
Please observe all local rules at the flying sites you use. It is important not to endanger the
preservation of flying sites that are a vital necessity to the enjoyment of our beautiful sport.