GIN Verso - Manual (Page 12)

12
Before you fly
CAUTION: Make sure that the speed
system is not too short. The front
risers of your paraglider must not be
pulled down in normal (unaccelerated)
flight.
Make sure your dealer has checked the harness for completeness and basic settings. Your
harness must be assembled by a suitably qualified paragliding professional, for example, your
instructor.
Gin Gliders recommend that assembly be carried out in the following order. If you are in any
doubt whatsoever about this procedure, please seek professional advice from your instructor, GIN
dealer or importer.
Installing the speed system
Assemble the speed system from top to bottom. Pass the cord of the speed bar through the
pair of pulleys near the side pocket and route it out through the black tube near the front corners
at each side of the seat. Attach the elastic cord to the speed bar to keep the speed bar flush with
the end of the seat plate when not in use. This allows easy access to the speed bar and prevents
tangling in case of a rescue deployment.
1
4
3
2