GIN Gingo Airlite - Manual (Page 12)

12
Back Protection
The Gingo Airlite is a harness with a built-in airbag. The airbag helps to absorb the force of an
impact by allowing air to dissipate progressively. This protects the pilot as much as possible in the
event of an incident, but it cannot completely eliminate the risk of injury. The Gingo Airlite back
protection is EN / LTF certified.
The Gingo Airlite is designed with a foam structure that helps pre-inflate the harness before
take-off. After launch the airbag will fully inflate via the air vents located on either side. Be sure
not to pack anything into the “rear compartment” during flight or this may block the air intake and
prevent the back protector from fully inflating. (see p. 25)
Triplex seat plate
Included with the Gingo Airlite is the new Triplex seat plate. 50% lighter than a wooden seat
plate with extended durability, the Triplex seat plate is the perfect fit for the new lightweight
harness. Pilots can also choose to upgrade to the carbon seat plate for additional weight reduction.
GIN carabiners
Included with your harness is a pair of GIN 30mm green carabiners. Other carabiners may also
be used with this harness but it is up to the pilot to check with a professional and ensure they are
compatible with this harness.