Philips FR999 - Manual (Page 26)

TROUBLESHOOTING
WARNING ^ occurs, first check the points listed before taking
Under no circumstances should you try to repair the
set yourself as this will invalidate the warranty. Do unable to solve a problem by following these hints,
not open the set as there is a risk of electric shock. consult your dealer or service center.
PROBLEM POSSIBLE CAUSE SOLUTION
Set does not work
and is in standby mode The overheating safety circuit
has been activated.
Switch the set off and let it cool down. After
letting the set cool switch it on again and
select a source by rotating SOURCE SELECT
or pressing a source key on the remote control.
No sound VOLUME is not adjusted correctly. Adjust the VOLUME.
Headphones are connected. Disconnect headphones.
The wrong source is selected. Turn SOURCE SELECT to select the correct
source.
No sound on the One speaker is connected incorrectly. Connect the speaker properly.
left or right side
A speaker cable is damaged. Replace the cable.
Volume balance in the receiver menu is
adjusted incorrectly.
Adjust I'uL rf?ui«'T-L andl'uL FRONT-f?
in the receiver menu.
Poor sound or no sound at
the center or surround
SURROUND mode is not switched on. Press SURROUND ON/OFF to switch on the
surround sound.
speakers
Surround and/or center speakers are not
(properly) connected.
Connect the speakers properly.
Surround and/or center speakers are switched Set speaker present to УЕ5.
off in the GPERKf? GfITuPmenu.
A speaker cable is damaged. Replace the cable.
Surround sound level is
too low or too high The level of the surround sound is not
adjusted properly.
Adjust the level of the surround sound on
the receiver.
Center sound level is too
low or too high The sound level of the center channel is not
adjusted properly.
Adjust the level of the center channel
on the receiver.
Only center speaker is
heard in Dolby Surround
Pro Logic A mono signal is reproduced. Choose a different sound source or switch off
surround sound.
Bad radio reception,
automatic programming
does not work properly Receiver or antenna is positioned near a
radiation source such as TV, CD player,
CD recorder, DVD player, etc.
Change the position of the interfering unit
or try to switch it off.
No digital recording
possible via digital output The sampling frequency is not accepted by
the digital recorder.
Make sure the digital recorder can handle
sampling frequencies between 32 kHz and 48 kHz
or make the recording via analog output.
The digital source is copy protected. Copying is not allowed.
Whole recording appears
as one track when
recording from DVD disc The DVD player does not provide track
information.
Record each track individually or use the
"manual track increment" feature on the recorder
No video signal on Connections are not made properly. Connect the cables properly.
your monitor/TV
Types of cables or video connections made
do not match.
Use same type of cable/video connection
for the connection between your video
appliance, the receiver and the monitor/TV.
Your monitor/TV does not support the video
signal provided by your video source.
Change the video signal on the video source or
your monitor/TV, if possible.
26