Cable tv, Connect the cable tv cable to, Set-up and quick use - vcr hookup – Philips XS1955 User Manual
Page 5: Refer to the owner's manual, And q
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S
et
-U
p
and
Q
uick
U
se
- C
able
H
ookups
C
able
TV
C
able
I
nput
/C
onverter
y
bur home may use a single (75
ohm) cable, or have a Converter
Box installation. Connect the thread
ed end of the cable signal to the TVs
antenna plug and screw it down.
(BEQIN)
If your Cable TV signal is a single
round cable (75 ohm) then you're ready
to connect to the TV.
If you have a Cable TV Converter
Box: Connect the Cable TV signal to the
Cable Signal Esi(put) plug on the
Converter.
Connect the Cable TV cable to
the ANTENNA/CABLE plug on the
TV.
If you have a Cable Converter
Box: Connect the Converter to the
ANTENNA/CABLE plug on the TV.
NOTE: The connecting cable for
the Converter is supplied from
the Cable TV Company.
Round Cable
150. Ohm
Remember, g
set the TV for the
type signal you've
just connected (see
page 7.)
To select only the
channel numbers on
your Cable system
see “Auto Install"
(page 7). If you use a
Cable Converter box,
set the TV to the
same channel as the
converter's CH 3/4
switch (on the rear of
the converter.)
S
et
-U
p
AND Q
uick
U
se
-
VCR
H
ookup
VCR
TO
TV
B
asic
C
onnection
T
^he basic Antenna, or Cable
TV, to VCR to TV connection
is shown to the right. For more
information on other hookups
refer to your accessory VCR and
Cable Converter Owner's Manual
for details.
C
begin
J
Connect your Antenna or Cable
TV signal to the IN FROM
ANT(enna) plug on the VCR.
<|> Connect the OUT TO TV plug
on the VCR to the ANTENNA plug
on the TV (connecting cable supplied
with the VCR).
Refer to the Owner's Manual
included with your VCR for other
possible connections and TV/VCR
operating details.
Back of TV
Round Cable
150 Supplied with VCR