Philips AW 7792 - Manual (Page 5)

CASSETTE PLAYBACK
Playback on deck B or A
During playback, the tape in the other deck should not
be fast forward wound or rewound, otherwise the actuai
cassette playback is affected.
• Set ON/OFF-MODE selector (3) to TAPE ([ 2 ] or [T]).
• Press EJECT m and insert a recorded cassette
(fig. 4).
• Adjust the sound with the controis VOLUME @ and
GRAPHiC EQUALIZER
• Press PLAY ► and playback will start.
• To stop playback, press STOP ■. The set is then
switched off.
removed using a soft and clean, slightly damp leather
cloth. Do not use any cleaning agents which contain
abrasives or solvents such as benzine thinner, alcohol,
refined petrol or ammonia, since they may affect and
harm the cabinet.
This product complies with the radio interference
requirements of the European Community.
Continuous play - A.
• Set ON/OFF-MODE selector (3) to TAPE {[2] or |i]).
• Press both EJECT buttons ■ and insert a recorded
cassette into both decks (fig. 4).
• Adjust the sound with the controls VOLUME ® and
GRAPHIC EQUALIZER ©.
• Press on deck B CONTINUOUS A^B On doing so,
PLAY ► is pressed too) and on deck A PLAY ►: deck B
will now play and deck A stands still.
As soon as deck B stops (at the end of the cassette or
when its STOP button ■ is pressed), deck A will start
playing back.
• When deck B is started again by pressing CONTINU­
OUS A. deck A will come to a standstill and deck B will
be reproduced again.
• To stop playback, press STOP ■. The set is then
switched off.
MAINTENANCE
Cassette decks
Clean the parts indicated in fig. 5 after every 50 hours of
operation or, on average, once a month.
• Open the cassette holder by pressing EJECT ■.
a Use a cotton bud slightly moistened with alcohol or a
special head cleaning fluid.
• Press PLAY ► and clean the rubber pressure roller ®
(fig. 6).
• Then press PAUSE II and clean the capstan ©,
recording/playback head ® and erase head ®.
• After cleaning, press STOP ■.
Cleaning of the heads ® and ® can also be done by
playing the cleaning cassette SBC 114 through once as
an ordinary cassette.
- The recorder-mechanisms are fitted with self-lubrica­
ting bearings and therefore must not be oiled or greased.
- Do not expose the set, batteries or cassettes to rain
or moisture, or. for any great length of time, to excessive
heat from heating equipment or direct sunshine, e.g. in
motor cars parked in the sun.
- Keep the set and the cassettes away from sand and do
not store the cassettes too close to magnets, loud­
speakers or transformers.
- Fingerprints, dust and dirt on the apparatus can be