Philips HP6378 - Manual (Page 10)

Contouring Eyebrows With Micro Trimmer
Use the micro trimmer on eyebrows without a comb attachment if
you are:
► Shaping eyebrows
I Defining eyebrow contours
►
Removing single, unwanted hairs
O Be certain trimmer is in the OFF position.
Q Put the micro trimmer attachment on the trimmer.
Q Switch the trimmer ON.
Q For contouring eyebrows, stretch the skin of the eyelid (fig. 19).
Be careful when you use the micro trimmer as it removes every hair it
touches.
Q Make well-controlled movements making sure the micro trimmer
is in full contact with the skin. Always move the micro trimmer
against the direction of hair growth.
Be careful not to use the micro trimmer too close to a mirror
IMPORTANT: Do not try to trim vour eyelashes. Be careful not to get
too close to vour eyelashes and eves!
Q Turn off trimmer. Rinse attachment clean after each use.
Cleaning
K The trimmer should be cleaned after each use.
►
Always switch trimmer OFF, unplug and remove power supply cord
from trimmer before cleaning.
I Do not use abrasive cleaning agents, scourers or liquids such as
alcohol, benzene, bleach or acetone to clean the trimmer and
attachments.
K Never clean, replace or remove trimmer attachments with motor
ON.
► Do not apply pressure to cutters.
I Do not touch cutters with hard objects as this may damage them.
During Use:
► If cut hairs have accumulated in the comb area, remove hairs by
shaking, blowing or using cleaning brush provided. Remember to
adjust the trimming length back to your selected setting when you
replace the comb on trimmer.
After Each Use:
U Make sure the trimmer is switched OFF and disconnected from
the electrical outlet.
a
Remove any comb and/or attachment from trimmer.
Q Blow and/or shake out any hair that may have accumulated in
the attachment and/or comb.
D To clean the micro shaver, pull the foil in the direction of the
arrow to remove from base of micro shaver (fig. 20).
H Clean the cutter and the inside of the shaving foil carefully with
the brush or under warm tap water.
Do not use a towel to dry the micro shaver as damage to the shaving
foil could occur
► The shaving foil is very delicate. Handle carefully.
► If foil becomes damaged, replace immediately. Do not continue
using the appliance. Do not apply pressure to shaving foil.
► Do not clean the foil with the brush, as this may cause damage.
Q Rinse attachments thoroughly under warm tap water.
Q Shake excess water from attachment and allow to dry thoroughly.
Q Place the attachment back on the trimmer.
This trimmer has no other user-serviceable parts. For assistance,
call 1-800-243-7884.