Futaba MPDX-1 - Manual (Page 2)

Note: The MPDX-1 can operate with T14MZ system
software from the following version: Editor: Ver.
1.0.1/encoder: Ver. 1.31
*Verify the software version at the information window of
the system menu. If the software is a version predating
the above, update the 14MZ software by downloading
the public update file from the Futaba dealer web site.
Ɣ8SWR03';FDQEHXVHGZLWKWKH7
MZ
Ɣ7KH 03'; FDQ EH FRQQHFWHG WR DQ\ FKDQQHO EHWZHHQ
FKDQQHOVDQG
Ɣ7KH IROORZLQJ IXQFWLRQV FDQ EH VHW IRU HDFK PXOWLSURS
expanded channel.
Operation control setting/Direction of operation reversal/
Travel adjustment
*However, mixing cannot be set at a multi-prop channel.
Multi-prop function assignment
2SHQWKHIXQFWLRQVHWXSZLQGRZRIWKHOLQNDJHPHQXDQGVHW
WKHIXQFWLRQRIWKHFKDQQHOWRZKLFKWKH03';LVFRQQHFWHG
WR0XOWLSURSRU0XOWLSURS
:LQGRZVZLWK0XOWLSURSDQG0XOWLSURSVHW
Operation control setting:
1 Open the operation setup window by pushing the
"MP CH" button of the channel with multi-prop set.
2 Open the control selection window by pushing the
button of the multi-prop channel to be set.
3 Select the control you want to operate.
Reverse setting:
1 Open the reverse setup window of the linkage menu,
and push the SET button of the channel with multi-
prop set.
2 The reverse setup window of the multi-prop channel
appears. Switch between "Normal" and "Reverse"
by pushing the SET button of the multi-prop channel you
want to reverse.
Travel adjustment:
1 Open the end point (ATV) window of the linkage
menu and push the "MP CH" button of the channel
with multi-prop set.
2 The end point (ATV) setup window of the multi-
prop channel opens. Press the display button (left or
right or up and down can be adjusted individually) of the
channel whose travel you want to adjust, and adjust the
rate by using the adjustment buttons at the bottom.
T14MZ Transmitter Setup
7KHVHWXSSURFHGXUHLVDOVRWKHVDPHIRUWKH);
- 2 -