beautypg.com

Futaba 6EXP User Manual

Page 19

background image

19

PMIX1/2 Programmable Mixer 1/2 (ACRO only)

Unlike the “wing mixing” function (explained later) where the channels to be mixed are factory-set, the T6EXP also contains
two programmable mix where the you, the pilot determine the channels to be mixed. This could be used to correct unwanted
flight tendencies (by mixing rudder to aileron, or aileron to rudder for example).

To set up a programmable mix:

1. Enter the programming mode. Access the “PMIX” screen with the MODE key.

2. Push the DATA INPUT lever upward for 0.5 seconds. This will cause the flashing “INH

display to change to a flashing “ON” display.

3. Push SELECT key to call the screen for selecting channels to control “MAS” (Master)

mixing. Then select the channel by pushing DATA INPUT lever . Channel 1 (aileron) in this
figure is assigned to the master.

4. Push SELECT key to call the screen for selecting channels to control “SLV” (Slave) mixing.

Then select the channel by pushing DATA INPUT lever. Channel 4 (rudder) in this figure is
assigned to the slave.

5. Press the SELECT key twice to display the flashing % sign. Use the DATA INPUT lever

to set the percentage of mixing from -100% to +100% (depending on the direction and
distance you wish the slave servo to move).

6. Push SELECT key to call the screen for selecting the on/off switch. Then select the switch

by pushing DATA INPUT lever. CH5, D/R, or FLP switch (include the on direction) is
selectable. The “ON” is “always on”.

7. Observe how the controls on the model respond to be certain you have achieved the correct

mix and that the throws are as desired.