Vermont Casting 43LDVR - Manual (Page 37)

37
LDVR Series Direct Vent Gas Fireplace
10007317
Ceramic refractory panels are available in kit form for
the LDV series appliances
Appliance Model Kit Name
33LDVR 33LDVRCR
36LDVR 36LDVCR
39LDVR 39LDVCR
43LDVR 43LDVCR
Ceramic Refractory Kits
The fireplace, when installed, must be
electrically connected and grounded in
accordance with local codes or, in the
absence of local codes, with the current
CSA C22.1 Canadian Electric Code.
For USA installations follow the local codes
and the national electrical code ANSI/NFPA
No. 70.
Should this fan require servicing or repair
the power supply must be disconnected.
For rewiring of any replacement parts refer
to Figure 53.
Any electrical rewiring of this fan must be
done by a licensed electrician.
Wiring Instructions
Black
White
Ground
FP394
WIRING DIAGRAM
11/20/96
Speed
Control
Temperature Sen-
sor
Fan
FP1025
Fig. 53 FK24 fan wiring.
Take care when handling the refractory
panels as they are fragile until held in place
and supported.
Installation Refer to Figures 54 & 55
1. Remove the front window frame assembly.
2. Remove the logs.
3. Place the rear refractory panel in place. Locate the
lower edge of the panel in the ledge formed by the
top of the rear log support bracket.
4. Slide the side refractory panels into place to hold
the rear panel secure. Repeat the procedure on the
other side.
5. Replace the logs and window frame assembly.
For aesthetic purposes we recommend aligning the
horizontal mortar lines.
FP1231
Ceramic panels
11/02
Side
Panel
Side
Panel
Log Support
Burner Tray
Back Panel
FP1231
Fig. 54 Ceramic panel installation.
FP1232
rear ceramic panel
11/02
Rear Refrac-
tory Panel
Firebox Back
Panel
Rear Panel
Support
Brackets
Rear Log
Support
FP1232
Fig. 55 Rear refractory panel installation.
Remote Controls
Optional remote control units are available to control
different functions of the appliances
Model Function/s Controlled
RCI ON/OFF
RC2 ON/OFF and Temperature
IMTFK Wall mounted thermostat control
(must be used in bedroom installations)