Fieldmann FZR 2020-E - Manual (Page 15)

15
OPERATING INSTRUCTIONS ELECTRIC LAWNMOWER
EN Lawnmower handle assembly | Grass catcher box assembly | Cutting height adjustment
6. LAWNMOWER HANDLE ASSEMBLY
(Fig. A)
Insert both ends of the lower parts of the handle into the respective holes and secure them
using bolts (A1).
Attach the supply cable holder to the upper part of the handle (A2)
Attach the upper part of the handle using bolts and star-shaped nut (A3).
Now you can fix the handle using the star-shaped nut (A3)
7. GRASS CATCHER BOX ASSEMBLY
(Fig. B)
Mounting the assembled grass catcher box onto the lawnmower.
Lift the safety guard
Make sure the discharge chute is not contaminated by soil or stones.
Attach the completed grass catcher box onto the positioning marks at the back of the
lawnmower as indicated in the photograph.
Close the safety guard on the grass catcher box and make sure it fits correctly.
8. CUTTING HEIGHT ADJUSTMENT (Fig. C)
ATTENTION! Before adjusting the cutting height, release the lever 1 and wait until the engine
completely stops. After switching the engine off, the cutting blades continue to rotate for a few
seconds; be careful to avoid the risk of injury by the rotating blades.
The cutting height can be adjusted by changing the attachment height of the front and
rear travelling wheels. (see Fig. C1 and C2); in total, the lawnmower has three possible
cutting heights.
CUTTING HEIGHT WHEEL POSITION
Low 25 mm
Medium 43 mm
High 62 mm
Note: For most lawns, the medium cutting height is the most suitable one. If you adjust too
small cutting height, you could impair the quality of mowing.