Fieldmann FZR 4621-BV - Manual (Page 11)

EN
PETROL LAWNMOWER USER'S MANUAL
11 Preparation and inspection before starting | Starting the lawnmower
2. After attaching the mulching accessory, check its stability.
3. Use only original mulching accessories when mulching.
4. Try not to mow tall grass all at once, this will prevent overloading the lawnmower mechanism and the engine.
When mowing grass that has grown too tall, we recommend that you reduce the speed of travel.
MOWING WITH SIDE DISCHARGE (fi gure 1 – point 10)
To attach the side discharge fl ap, lift up the side chassis cover on the lawnmower (fi gure 1 - point 12). Secure the
fl ap (fi gure 1 – point 10) in place using hooks which fall under the shaft of the cover. When mowing with side
discharge, it is necessary to place the mulching plug into the discharge chute.
INSPECTION BEFORE STARTING
Check that all nuts and bolts are fi rmly tightened, paying special attention to fast moving parts such as the blade.
Use only original parts and install them correctly.
Set the handle position.
Attach the grass catcher. Check that it is sitting fi rmly in position.
Set the desired mowing height.
6. STARTING THE LAWNMOWER
1. If the motor is cold before start up, press the fuel primer bulb 3-5 times (fi gure 1 – point 15)
2. Pull the switch / brake lever (fi gure 1 – point 1) towards the handle of the lawnmower
3. Pull on the starting handle (fi gure – point 5). Do not release the starting handle quickly, this could result in
damage to the engine or other components by kickback. The starting cord must return slowly by the power of
the return spring
4. When the travel lever (fi gure 1 - point 4) is pulled to the handle, the lawnmower will start moving forward
5. To stop, release the travel lever (fi gure 1 – point 4)
6. To turn off the engine release the Switch/brake lever (fi gure 1 – point 1)
Dangerous! The blade is active when the engine is running. If you touch the blade at this point, you may
suffer serious injuries.