Fieldmann FZS 2002-E - Manual (Page 15)

15
OPERATING INSTRUCTIONS ELECTRIC STRING TRIMMER
EN Assembly instructions | Operation
Remove the worn spool from the trimmer and dispose the remaining string on the spool.
Pass the string end through the spool neck, see figure 6. Make sure the spring is securely
placed under the spool. Place the spool to the cutting head and pull the string through the
opening in order to create sufficient tension, see figure 6.
Note: Be careful, the head contains the spring which can get easily lost. Make sure the
spring is securely placed in its position.
Press the spool slightly downwards to the spring while turning it, until it gets engaged. Check
that the string is not snagged under the spool.
Click the cover shut back in the position, place the string trimmer in the operation position and
turn it on. Within a few seconds, you will hear that the nylon string is cut to the appropriate
length. If not, tap slightly with the trimmer head to the ground in order to release the
appropriate length of the string.
Adjustable Handle Attachment (Fig. 7)
Turn the handle knob (3) and pull out the screw (2) of the adjustable handle (1).
Insert the adjustable handle (1) to the trimmer handle.
Insert the screw (2) and the handle knob (3) back and tighten the knob slightly.
Prior to final tightening of the knob (3), turn the adjustable handle (1) to the desired angle.
When the adjustable handle (1) is in the required position, tighten the handle knob finally (3).
Edge Guide Wheel Assembly (Fig. 8)
WARNING!
The edge guide wheel assembly (1) may or need not be used to cut grass
(operation position A).
The edge guide wheel assembly (1) must be used to cut edges (operation position B).
The edge guide wheel assembly (1) must not be used to cut grass (operation position C).
While fixing the edge guide wheel assembly (1) to the guide (2) of the handle, you will hear a
click when the lock gets engaged on one side.
remove the edge guide wheel assembly from the trimmer, press the „PUSH“ button and pull
out the assembly from the guide (2) of the trimmer handle.
7. OPERATION
WARNING! RISK OF INJURY! There is an imminent risk of injury in case the string trimmer
does not turn off after you have released the trigger. Never override the safety devices (e.g. by
strapping down one of the start buttons).