Charmglow GRILL 720-0230 - Manual (Page 22)

USING THE SIDE BURNER
WARNING: IMPORTANT!
USING THE SIDE BURNER:
Inspect the gas supply hose prior to turning the gas
“ON”. If there is evidence of cuts, wear or abrasion, it
must be replaced prior to use. Do not use the side burner
if the odor of gas is present.
WARNING: Always keep your face and body as far
away from the burner as possible when lighting.
LIGHTING INSTRUCTIONS
To light the side burner, remove any cooking utensils
from the burner grate. Push and turn the control knob counterclockwise to the “HI” position. If the burner does
not light, turn the control knob to “OFF”. If the smell of
gas is detected and the igniter is not functioning,
immediately turn the control knob “OFF”. Allow 5
minutes for any accumulated gas to dissipate. If the side
burner igniter is not functioning, see the following
section for match lighting.
MATCH LIGHTING
Hold a lit extended match or lighter near the side burner
ports, turn the control knob counterclockwise to “HI”.
Move your hand immediately once the burner is lit.
Rotate the control knob to the desired setting.
CARE & MAINTENANCE
STAINLESS STEEL
The grill is made from stainless steel. There are many
different stainless steel cleaners available. Always use
the mildest cleaning procedure first, scrubbing in the
direction of the grain. To touch up noticeable scratches
in the stainless steel, sand very lightly with dry 100 grit
emery paper in the direction of the grain. Specks of
grease can gather on the surfaces of the stainless steel
and bake on to the surface and give the appearance of
rust. For removal use an abrasive pad in conjunction with
a stainless steel cleaner.
GRILL RACK
The easiest way to clean the grill is immediately after
cooking is completed and after turning off the flame.
Wear a barbeque mitt to protect your hand from the heat
and steam. Dip a brass bristle barbeque brush in tap
water and scrub the hot grill. Dip the brush frequently in
the bowl of water. Steam, created as water contacts the
hot grill, assists the cleaning process by softening any
food particles. The food particles will fall and burn. If
the grill is allowed to cool before cleaning, cleaning will
be more difficult.
ENSURE THAT THE GAS SUPPLY AND THE
KNOBS ARE IN THE “OFF” POSITION. MAKE
SURE THE RANGETOP BURNER IS COOL
BEFORE REMOVAL.
GRILL BURNERS
Extreme care should be taken when moving a burner as it
must be correctly centered on the orifice before any
attempt is made to relight the grill. Frequency of
cleaning will depend on how often you use the grill.
GRILL BURNER CLEANING
Ensure the gas supply is off and the knobs are in the
“OFF” position. Make sure the grill is cool. Clean the
exterior of the burner with a wire brush. Clear stubborn
scale with a metal scraper. Clear any clogged ports with
a straightened paper clip. Never use a wooden toothpick
as it may break off and clog the port. Please note if
insects or other obstructions are blocking the flow of gas
through the burner, and if so you will need to call our
customer service line.
GREASE TRAY CLEANING:
The grease tray should be emptied and wiped down
periodically and washed in a mild detergent and warm
water solution. A small amount of sand or cat litter may
be placed in bottom of grease tray to absorb the grease.
Check the grease tray frequently, don’t allow excess
grease to accumulate and overflow out of the grease tray.
20