Charmglow GRILL 720-0230 - Manual (Page 12)

10
ASSEMBLY INSTRUCTIONS
Side burner valve assembly:
Step 1: Insert valve assembly through side Step 2: Remove 4(four) screws & washers
panel from the “U” brackets on the side
burner
Step 3: Insert valve stem assembly into burner Step 4: Insert valve stem assembly through knob
venturi hole to the control panel
Step 5: Replace “U” brackets with 4(four) Step 6: Align & tighten knob bezel & valve
Screws( DO NOT TIGHTEN) stem with 2(two) screws & washers
as shown below.
(knob bezel in bag)
Valve
(Side panel, right #18B)
Valve
(Control Panel #32 )
Valve Stem
#37
#32
# 37
Step 7; Tight all 4(four) screws on the “U” Step 8: Place knob on valve stem, then screw
brackets on the burner, then connect the knob by using the Allen wrench.
the ignition wire on to valve.
(Allen wrench enclosed in bag )
(Ignition wire)