Envion TPH100 - Manual (Page 5)

CLEANING THE WATER TANK
1. Pour out all the water in the tank.
2. Rinse the water tank with clean, warm water.
3. If the tank has hard water deposits, add a small amount of white vinegar into the tank
and fill half the tank with warm water. Tighten the tank lid, and shake the tank several
times before emptying the water. Rinse the tank with warm, clean water again before using.
DEMINERALIzATION FILTER REPLACEMENT
To keep the Therapure® Humidifier functioning at maximum performance, it is recommended to
replace the demineralization filter cartridge once every 30–40 fillings under normal use, or when the
humidifier has not been operated for an extended period of time. NOTE: Operating the humidifier
without a demineralization filter cartridge will require more frequent cleaning of the unit base.
To purchase demineralization filter replacement cartridges please visit
www.envionproducts.com or call 1.800.554.6168 | Part# TPH1000F
STORAGE
1. Always empty and clean the unit before storage (see Cleaning and Maintenance).
2. Use a soft cloth to wipe dry the entire unit, including inside the water tank.
3. Pack into the original box and store in a cool, dry place.
cleaning & MainTenance
To replace the demineralization filter, (1.)
first remove the water tank lid (2.) from
the unit. Then remove demineralization
filter from the water tank lid by turning
it counter-clockwise. Replace with a new
demineralization filter and attach onto the
water tank lid in a clock-wise direction.
Then place both pieces back on unit to
complete filter replacement process.
conTrol Panel
CONTROL PANEL
To keep the Therapure® Humidifier functioning properly and at maximum performance,
it is recommended to clean the unit once a week.

Always turn off and unplug the unit first before doing any maintenance.
 Do not submerse the unit in water or allow water to enter inside the unit.
CAUTION: Water inside the unit may be hot. Allow the unit to cool
down for 5 minutes before performing any maintenance.
CLEANING THE UNIT BASE
1. Pour out all the water in the unit base.
2. Wipe the outer surface of the unit with a soft damp cloth.
3. Rinse out and wipe down the inside of the base with clean water by using the cleaning brush
included and a soft cloth, if needed.
4. If there are hard water deposits inside the ultrasonic nebulizer, add a solution of 50% white
vinegar and 50% water to the ultrasonic nebulizer. Let the water soak for 5 minutes. Clean the
ultrasonic nebulizer with the cleaning brush until the scale is removed. Rinse the ultrasonic
nebulizer with clean water.
Water tank lid
Demineralization filter 1
2
6
TPH100
7
TPH100
COLD/HOT
POWER
TIMERS ET
HUMIDITY
SPEED