Emerson Radio CKS9005BK - Manual (Page 16)

15
5. The receiving indicator “ ” will blink on the outdoor temperature display.
NOTE: The receiving indicator “ ” will blink for 3 minutes until
receiving the wireless Thermo Sensor code, it will stop blinking once
the code is received. The temperature will then be displayed.
If the receiving indicator “
” disappears, it means that the connection
was lost, press the “SYNC” button again to restart the process.
6. Press the “RESET” button on the Wireless Thermo Sensor once, this
will transmit the code and temperature data approximately every 5
seconds to the main unit. It will transmit the code and temperature
data continuously for 5 minutes, after 5 minutes the code
synchronization will stop and only the temperature date will transmit.
If the synchronization is not completed within 5 minutes you will have
to repeat steps 4 -6 again.
Once the code synchronization is successful, the outdoor temperature will show on the display
and the receiving indicator will stop blinking.
7. Place the wireless Thermo Sensor outside. The outdoor temperature display temperature
display will show the outdoor temperature.
Placing The Wireless Thermo Sensor At Outdoor
1. The Thermo Sensor should be located in an area protected from the
sunlight and rain. Mount the sensor under a covered location like a roof
overhang, this will ensure an accurate temperature reading.
2. The main unit should not be placed close to any electrical appliances such
as a computer, TV, monitor etc.
3. The MAX distance between the main unit and Thermo Sensor must be an
open area within 80 feet. If there are any obstructions between the main
unit and sensor, the distance will need to be shorter than 80 feet. Once
the outdoor temperature appears on the display, the distance between the two is good.
4. If the temperature reading is lower than –15 o C / 5 o F, the display indicates “LL”; If the
temperature is higher than 55 o C / 131 o F, the display indicates “HH”.
IMPORTANT:
Select the desired locations for the “Wireless Thermo Sensor” and main unit, if the “Outdoor
Temperature Display” shows “F - -” or “C - -”, that means the outdoor “Wireless Thermo Sensor” is
too far away from the main unit, please re-locate either the “Wireless Thermo Sensor” or main unit
until the “Outdoor Temperature Display” shows the temperature reading and the receiving indicator
“
” lights on.
Change the temperature mode:
Set TEMP. (Centigrade/ Fahrenheit) selector to the desired temperature mode. When the
Centigrade (Fahrenheit) temperature appears in the display, set the TEMP. to the “F” (“C”) position,
the temperature will change into the Fahrenheit (Centigrade) mode.