Remote control, 8battery installation (batteries are not supplied) – Emerson Radio BAR322 User Manual
Page 9
EFFECTIVE DISTANCE OF THE REMOTE CONTROL TRANSMITTER
When there is an obstacle between
the TV and the
may not operate.
When direct sunlight, incandescent
lamp, fluorescent
shines on the
REMOTE SENSOR of the TV, the
remote operation may be unstable
transmitter, the
transmitter
lamp or any other
strong light
.
NOTES:
REMOTE CONTROL
8
BATTERY INSTALLATION (batteries are not supplied)
Loosen the screw to open
the battery compartment
cover.
Install two (2) “AAA”
batteries,
attention
to the polarity
battery compartment.
paying
diagram in
the
Screwed the battery
cover on the
battery
compartment
compartment.
Follow these precautions when using batteries in this device:
1. Replacement of batteries must be done by an adult.
2. Do not mix old and new batteries.
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
4. The supply terminals are not to be short-circuited.
5. Non-rechargeable batteries are not to be recharged.
6. Exhausted batteries are to be removed.
7. Only batteries of the equivalent type are to be used.
8. Batteries are to be inserted with the correct polarity.
9. Do not dispose of batteries in fire; batteries may explode.
BATTERY PRECAUTIONS
30
30
20ft
1. POWER Button
2. Buttons (For Channels 0-9)
3. DISP. (display
10. Channel Up (
) and Down (
) Button
11. MUTE Button
) Button
4. V-CHIP Button
5. MENU Button
6. Volume Up (
) and Down (
) Button
7. SOURCE Button
8. SLEEP Button
9. CCD Button
1
2
3
AAA
AAA
AAA
AAA
1
2
3
4
5
6
7
8
9
0
DISP.
SLEEP
MENU
VOL
CH
SOURCE
MUTE
CCD
V CHIP
1
2
3
4
5
6
7
8
9
10
11