Emerson Radio MS9923TT - Manual (Page 13)

12
LISTENING TO THE RADIO
Radio Operation
1.) Press the STANDBY (POWER) button to turn the system ‘On’. The STANDBY
indicator goes ‘Off’. The LCD display and the EQ indicator light up.
2.) Press the TUNER/BAND button to select the Radio mode.
3.) To switch between AM and FM bands, press the TUNER/BAND button again.
If you tune in a FM stereo station, and the
the FM ST.– MONO button is set at FM ST.
position, the STEREO indicator will
appear on the LCD display.
4.) Press the TUNING or TUNING buttons to tune to the desired station as
follows.
Manual Tuning
Press the TUNING or TUNING buttons as many times as required until
the frequency of the desired station appears on the display.
Automatic Tuning
Press and hold the TUNING or TUNING buttons for approximately 2
seconds. The Tuner will begin scanning up or down automatically and will lock
onto the next strong signal.
5.) Adjust the VOLUME, BASS BOOST and EQ controls as desired.
MS9923TT_B022806.p65 28/2/2006, 9:44 12