Emerson Radio MS9923TT - Manual (Page 12)

11
OPERATING INSTRUCTIONS
GENERAL CONTROLS
PRESET Electronic EQUALIZER
When the unit is switched ‘On’ for the first time, the Equalizer will be in the “Flat”
setting. Press the appropriate PRESET EQUALIZER button to select “ROCK”,
“POP”, “CLASSIC” or “FLAT” sound effect to suit your taste. The appropriate EQ
Indicator lights to confirm your selection.
BASS BOOST System
The Bass Boost feature intensifies low frequency sound for richer bass reproduction.
1.) Press the BASS BOOST button once to activate Bass Boost. The BBS indicator
will light up.
2.) To turn ‘Off’ the Bass Boost system, press the BASS BOOST button again.
The BBS indicator will go ‘Off’.
NOTE: If you are listening to music with heavy bass at high volume, with EQ
set to “ROCK” and BASS BOOST ‘On’, you may experience some distortion.
If this occurs, set the EQ to “FLAT”, switch the BASS BOOST ‘Off’, or reduce
the volume.
MUTE Button (On Remote Control Only)
To temporarily shut off the sound from the speakers press the MUTE button on the
remote control.
The MUTE indicator will appear on the LCD
display. Press the MUTE button again to cancel
Mute and restore the sound. The MUTE indicator
goes “Off”.
FM ST.– MONO / HI-SPEED DUBBING Button
This button is used to select between the FM STEREO and FM MONO operation
modes. It is also used to select either Normal Speed or High Speed tape pe
dubbing.
To receive FM Stereo broadcasts this switch must be set to the FM ST. position.
However if you are listening to a distant or weak FM Stereo station and reception is
unsatisfactory, press the button to the MONO position may provide some
improvement.
MS9923TT_B022806.p65 28/2/2006, 9:44 11