Preparation for use (continued) – Emerson Radio GP208 User Manual

Page 4

Battery Operation

The battery compartment is located on the bottom of the cabinet.
• Remove the battery compartment door by sliding the battery compartment open.
• Insert 8 ‘C’ size (UM-2) batteries into the battery compartment as shown in the figure below. Be sure to

observe the polarity markings which are engraved inside the battery compartment. If the batteries are
inserted incorrectly, the unit will not operate.

• Replace the battery compartment door.

NOTE: The AC power cord must be disconnected from the AC jack on the back of the unit in order for the
unit to operate on battery power.

BATTERY PRECAUTIONS

Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.

Reversed batteries may cause damage to the device.

3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh

ones.

4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury

from possible battery leakage.

5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.

(Follow battery manufacturer’s directions.)

PREPARATION FOR USE (CONTINUED)

GP208 O/M.QXD 7/24/02 1:43 PM Page 4