EDCO TMS-10 - Manual (Page 7)

Printed in USA
TVW
© 2004
Page 7
E-TMS10-I-0504
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: [email protected]
Before Starting:
• Read and understand the instructions supplied by the motor manufacturer.
• Familiarize yourself with all saw controls. (Figures 2-4)
• Visually inspect the entire machine for damage or wear. Remove excess dirt or debris. Check that all nuts, bolts and
screws are tightened. Check for proper alignment of moving parts, possible binding of moving parts, breakage of parts,
loose mounting brackets, and any other condition that might affect operation.
• Inspect diamond blade and arbor shaft. Check blades for cracks, loose segments, worn or out-of-round arbor holes.
Do not use warped, twisted, out-of-balance blades or any blade of questionable condition. (Figure 7)
• If wet cutting, fill the water tray with water. The water pump recycles the water from the tray, plug the drain hole and be
sure the water is circulating from the tray to the water pump. Clean water pump daily using at least 5 gallons of clean
water.
• If wet cutting, with an external source of water, such as a water barrel, open the drain plug in the water tray and make
sure the water has somewhere to go that is clear of the working area. One option is to hook up a second water hose.
(Figure 6)
Figure 6 Figure 5
Blade Diameter
Arbor Shaft Diameter
Max Cutting Depth
Arbor Speed
10 inches
5/8”
3 3/4”
1 HP - 2400 RPM
1 1/2 HP - 3400 RPM
Use Diamond Blades Only