EDCO SS-16A - Manual (Page 7)

E-SS20/16A-I-0607
Printed in USA
TVW
©2007
Page 7
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: [email protected]
®
A Division of Equipment Development Company, Inc.
For Dry Cutting:
Consult Blade Manufacturer
for Maximum Depth of Cut.
Starting and Controlling the Cut:
• Engine must be at FULL THROTTLE.
• Move CLUTCH lever to DRIVE position and adjust SPEED CONTROL (Figure 8).
• Pull knob up on the Depth Control Handwheel (Figure 6), slowly turn Handwheel in
DOWN direction (counter clockwise) until blade comes in contact with slab surface.
• Set the Depth Gauge (Figure 7) at ZERO .
• Continue turning the Handwheel until blade has penetrated the slab to
desired depth.
Note: Depth gauge is an approximate measurement - it is not exact.
Never cut deeper than the maximum depth of cut for the blade being used.
Only cut in a forward direction.
Always cut with the engine at full throttle.
Controlling Speed:
• The SS-20 and SS-16A uses a hydrostatic transmission, chain and friction
drive mechanism that engages both rear wheels to achieve forward and
reverse movement. Machine speed is controlled by using the Speed
Control lever.
Actual cutting speed is determined by type of blade, material to be
cut and depth of cut. Adjust forward speed to meet cutting conditions.
Note: If while cutting, the front wheels start to lift, reduce forward speed.
For positioning the saw, the maximun forward speed is 200ft.
per minute. For safety reasons when in reverse, the SS-20 and SS-16A is
designed to move at a slow walking pace. Do not force it to go faster.
Left or Right Side Cutting:
• If circumstances require a left side cut, see page 11 for instructions on
moving the blade and blade guard.
Figure 7
Figure 8
Figure 6
Wet Cutting Only: SS-20 SS-16A
Maximum Depth of Cut
for 14” diameter blade........... 4 3/4” 4 3/4”
for 16” diameter blade........... 5 3/4” 5 3/4”
for 18” diameter blade........... 6 3/4”
for 20” diameter blade........... 7 3/4”
Figure 5