EDCO SS-16A - Manual (Page 13)

E-SS20/16A-I-0607
Printed in USA
TVW
©2007
Page 13
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: [email protected]
®
A Division of Equipment Development Company, Inc.
Changing To Left-Side Cutting:
• Disconnect water hose from the blade guard.
• Using SAE 9/16” and 3/4” wrenches, remove the bolts on the blade guard.
•
On the other side of the machine, remove the arbor shaft guard.
• You will have to re-route the water hose to the other side of the engine. It may be necessary to pull the hose back
through the hole in the main body of the machine and allow it to run directly up the left side. Be sure that the hose
will not interfere with or get caught on any moving parts.
• Reattach both guards.
• Reattach hose to the blade guard.
Blade Guard Left Side Arbor Shaft Guard
Possible Diamond Blade Problems
Possible Diamond Blade Problems
Segment Loss:
Usually insufficient
water
Cracked Segments
and/or Core
Wrong Blade for the job.
Blade Will Not Cut:
Blade is glazed or
to hard for the job.
Arbor Hole
Out-Of-Round
Blade not properly tightened
or seated on arbor.