EDCO TS-14 - Manual (Page 8)

Page 8
TS-14-I-0714
800-638-3326 • edcoinc.com • [email protected]
EQUIPMENT DEVELOPMENT CO., INC.
Maintenance
• All maintenance should be performed regularly and by qualifi ed personnel only.
• Lubricate the wheel bearings from time to time with an occasional drop or two of
light oil to prevent binding.
•
Keep the TS-14 clean.
• Be sure the safety decals are readable and properly maintained on the machine.
2 pumps every 2 months
Disconnect the power source at the machine and remove blade before
performing any maintenance.
Repairs are to be done
by authorized EDCO
Dealers only. Read and follow
instructions in the engine
owner’s manual.
Quick Reference
For Maintaining
the TS-14
Before Each
Operation
After Each
Use
As
necessary
Visual Inspection of Machine and
Power Cord
X
Inspect Blade
X
Clean dust, dirt and mastics
from machine
X
Grease Striker Plate
Driver Shaft Bearings (2 ea)
X