Ecler UMAI SERIES - Manual (Page 7)

7
9. INSTALLATION
The UMAi series has been designed to offer the greatest possible flexibility and easiness
concerning installation and transport.
Each model of the range has milled lateral handles and an additional handle on the
backside which are helpful during the installation of the speakers.
In the following we explain the possibilities of installation for each of the speakers from the
UMAi series.
UMA112i
Includes 12 embedded nuts with M10 thread that allow to hang-up the speaker inserting
hooks, to which chains or steel cables can be attached. Also offers a standard 35mm pole socket for
mounting on ECLER TRIP01 tripod, ECLER SR12 wall anchor or ECLER POLE01 accessory for fast
configuration to the UMA SB118i subwoofer unit. (see included diagram)
UMA115i
Includes 12 embedded nuts with M10 thread that allow to hang-up the speaker inserting
hooks, to which chains or steel cables can be attached. Also offers a standard 35mm pole socket for
mounting on ECLER TRIP01 tripod.
UMA SB118i
The UMA SB118i subwoofer has been designed to be installed on horizontal surfaces.
Includes 12 embedded nuts with M10 thread that allow to hang-up the speaker inserting hooks, to
which chains or steel cables can be attached and pole socket for inserting 35 mm shank of ECLER
POLE01. This unit is also prepared to stack other UMA SB118i or UMA112i / UMA115i units, due to
milling on the upper side.
IMPORTANT NOTE
In no case should these equipments be suspended via their carrying handles; use
the accessories adapted to each application. Whenever loudspeakers are wall or ceiling
mounted, a redundant mounting system is obligatory as safety measure. Use a steel cable or
chain of suitable gauge to avoid the fall of the loudspeaker in case some element of the main
suspension system would break away from its fastening device.