ebm-papst K3G200-BDA4-04 - Manual (Page 9)

Operating instructions K3G200-BDA4-04
Translation of the original operating instructions
Overtemperature of
electronics/motor Insufficient cooling Improve cooling. Let
the device cool
down.
To reset the error
message, switch off
the mains supply
voltage for a min. of
25 s and switch it on
again.
Ambient temperature
too high Reduce the ambient
temperature.
Reset by reducing
control input to 0.
Unacceptable
operating point Correct the operating
point. Let the device
cool down.
If you have any other problems, contact ebm-papst.
5.1 Cleaning
NOTE
Damage to the device during cleaning.
Malfunction possible
→ Do not clean the device using a water jet or high-pressure
washer.
→ Do not use any cleaners containing acids,
bases or solvents.
→ Do not use any pointed or sharp-edged objects to clean.
5.2 Safety test
What has to
be tested? How to test? Frequency Which
measure?
Check the
protective
casing against
accidental
contact for
damage and to
ensure that it is
intact Visual inspection At least every
6 months
Repair or
replacement of
the device
Device for
damage Visual inspection At least every
6 months
Replace device
Mounting the
connection lines Visual inspection At least every
6 months
Fasten
Check the
insulation of
the wires for
damage Visual inspection At least every
6 months
Replace wires
Impeller for
wear/deposits/
corrosion and
damage Visual inspection At least every
6 months
Clean or
replace impeller
Item no. 50969-5-9970 · ENG · Revision 82270 · Release 2014-10-23 · Page 9 / 9
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · [email protected] · www.ebmpapst.com