ebm-papst K3G200-BDA4-04 - Manual (Page 5)

Operating instructions K3G200-BDA4-04
Translation of the original operating instructions
3.2 Nominal data
Motor M3G074-CF
Nominal voltage / VDC 48
Nominal voltage
range / VDC 36 .. 57
Type of data definition fa
State prelim.
Speed / min -1 5050
Power input / W 320
Current draw / A 6.7
Max. back pressure / Pa 750
Min. ambient temperature
/ °C -25
Max. ambient
temperature
/ °C 50
ml = Max. load · me = Max. efficiency · fa = Running at free air
cs = Customer specs · cu = Customer unit
Subject to alterations
3.3 Data according to ErP directive
Installation category A
Efficiency category Static
Variable speed drive Yes
Specific ratio * 1.01
* Specific ratio = 1 + p fs / 100 000 Pa
Actual Request
2013 Request
2015
Overall efficiency η es / % 47.5 31.6 34.6
Efficiency grade N 62.9 47 50
Power input P e / kW 0.34
Air flow q v / m³/h 800
Pressure increase total p sf / Pa 660
Speed n / min -1 4915
Data definition with optimum efficiency.
The ErP data is determined using a motor-impeller combination in a standardised
measurement configuration.
3.4 Technical features
Mass 2.26 kg
Size 200 mm
Surface of rotor Coated in black
Material of impeller PA plastic
Housing material PA plastic
Material of support
bracket PA plastic
Number of blades 7
Direction of air flow "V"
Direction of rotation Clockwise, seen on rotor
Type of protection IP 44; Depending on installation and
position
Insulation class "B"
Humidity class F2-1
Mounting position Any
Condensate discharge
holes None
Operation mode S1
Motor bearing Ball bearing
Technical features - Tach output
- Motor current limit
- Soft start
- Control input 0-10 VDC / PWM
- Over-temperature protected electronics
Motor protection Reverse polarity and locked-rotor
protection
Cable exit Lateral
Product conforming
to standard EN 60335-1
Approval CCC
For cyclic speed loads, note that the rotating parts of the device
are designed for maximum one million load cycles. If you have
specific questions, contact ebm-papst for support.
3.5 Mounting data
For depth of screw, see chapter 3.1 Product drawing
; Secure the mounting screws against accidentally coming loose (e.g.
by using self-locking screws).
Strength class for
mounting screws 8.8
You can obtain additional mounting data from the product drawing if
necessary.
3.6 Transport and storage conditions
; Use the device in accordance with its protection type.
Max. permissible
ambient motor temp.
(transp./ storage) + 80 °C
Min. permissible
ambient motor temp.
(transp./storage) - 40 °C
3.7 Electromagnetic compatibility
EMC interference
immunity Acc. to EN 61000-6-2 (industrial
environment)
EMC interference
emission Acc. to EN 55022 (Class B, household
environment)
Item no. 50969-5-9970 · ENG · Revision 82270 · Release 2014-10-23 · Page 5 / 9
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · [email protected] · www.ebmpapst.com