Dromida DB4.18 Assembly Guide - Manual

HELPFUL HINTS
✔ Avoid working over a deep pile carpet. If you drop a small part or screw,
it may be difficult to find.
✔ Place a mat or towel over your work area. This will prevent parts from rolling off and will protect the work surface.
✔ Avoid running the car in cold weather. The plastic and metal parts can become brittle at low temperatures. In addition, grease and
oil become thick, causing premature wear and poor performance.
MAINTENANCE
BEFORE EACH RUN
✔ IMPORTANT: Check to make sure that all
screws are tight. Check that the servo
saver screw is fully tightened to ensure
that your Dromida DB4.18 tracks straight.
✔ Always check the condition of your
radio system batteries and replace if
necessary.
✔ Check to make sure that all of the
moving parts of the Dromida DB4.18
move freely and do not bind.
✔ Turn on the radio and make sure the
servo moves easily and in the proper
direction.
✔ Check for any broken or damaged
parts. Replace them before running the
Dromida DB4.18. Running the Dromida
DB4.18 with broken or damaged parts
could damage additional parts.
✔ Check to make sure that all wires are
properly connected.
AFTER EACH RUN
✔ Clean any debris from the chassis and
moving parts.
✔ Check for any broken or damaged parts.
Replace them before the next run.
✔ Disconnect and remove the battery
from the chassis.
AFTER EVERY 10 RUNS
✔ Check to make sure that the bearings
are free of dirt and debris, and roll
smoothly.
✔ Check the shocks for oil leakage.
✔ Check the tires to make sure they are
still properly glued to the rims.
ASSEMBLY AND MAINTENANCE GUIDE
HARDWARE CHART
2x10 MM FLAT HEAD SCREW H
2x4 MM ROUND HEAD SCREW
C
2x8 MM FLAT HEAD SCREW
G
2x8 MM ROUND HEAD SCREW
E
2x10 MM ROUND HEAD SCREW
F
6x10 MM BALL BEARING
A
8x12 MM BALL BEARING
B
2x8 MM ROUND HEAD
SHOULDER SCREW
P
3x3 MM SET SCREW Q
3 MM LOCK NUT
R
2.6x5 MM WASHER
S
3x6 MM WASHER
T
2x6 MM SELF-TAPPING
ROUND HEAD SCREW
X
2x12 MM SELF-TAPPING
ROUND HEAD SCREW
Z
2x15 MM SELF-TAPPING
ROUND HEAD SCREW
AA
2x5 MM SELF-TAPPING
ROUND HEAD SCREW
Y
2x14 MM FLAT HEAD SCREW
J
2.5x8 MM FLAT HEAD SCREW
K
2.5x8 MM SOCKET HEAD SCREW
L
2.5x14 MM SOCKET HEAD CAP SCREW M
3x6 MM SOCKET HEAD SCREW
N
3x6 MM SELF-TAPPING
BUTTON HEAD SCREW
CC
3x8 MM SELF-TAPPING
BUTTON HEAD SCREW
DD
2.5x5 MM BUTTON HEAD
SCREW
BB
BODY CLIP V
1.5 MM E-CLIP U
ACTUAL SIZE (WHEN PRINTED AT 100%)
™