Drawmer S2 Dual Channel Tube Compressor - Manual (Page 4)

4 DRAWMER S2 O
PERATOR’S M ANUAL
The S2 is designed for standard 19" rack mounting and
occupies 3U of rack space. Fibre or plastic washers may
be used to prevent the front panel becoming marked by
the mounting bolts. Always connect the mains earth to
the unit.
Because the S2 contains six valves it will generate more
heat than a simple solid state unit. Avoid mounting the
unit directly above power amplifiers or power supplies that
radiate significant amounts of heat. In addition it is advised
that you leave at least 1U of space above to allow heat to
dissipate. Alternatively, a fan should be fitted somewhere
near to the rear of the unit to circulate cooler air and help
expel any excess heat. (see fig. 1)
INSTALLATION
fig.2 TYPICAL S2 SETUP
fig.1 RACK MOUNT POSITIONING