beautypg.com

Power connection – Drawmer DL241 Auto Compressor User Manual

Page 6

background image

DL241 OPERATORS’ MANUAL

4

POWER CONNECTION

The unit will be supplied with a power cable suitable for domestic power outlets in your
country. For your own safety it is important that you use this cable. The unit should
always be connected to the mains supply earth using this cable

If for some reason the unit is to be used at a mains input operating voltage which is
different to that as supplied, the following procedure must be carried out. (see following
diagram)

1:

Disconnect the unit from the mains.

2:

Using a number 1 size pozidrive screwdriver, remove the two self-tapping

screws holding the voltage selection switch cover plate on the rear panel.

3:

Remove the cover plate and slide the switch fully to its opposite end.

4:

Rotate the cover plate one half turn, (180E) and refit the two screws.

5:

Replace with a correctly rated fuse for the selected operation voltage.

6:

Re-connect to mains power source.