Dodge 2010 Ram Pickup 3500 Diesel - Manual (Page 15)

To reset a trip odometer, display the desired trip odom-
eter to be reset then push and hold the button for
approximately two seconds until the display resets.
When the appropriate conditions exist, the following
messages will display in the Electronic Vehicle Informa-
tion Center (EVIC). Refer to “Electronic Vehicle Informa-
tion Center (EVIC)” in “Understanding Your Instrument
Panel” for further information.
Water in Fuel . . . . . . . . . . . . . . . . . . . . . . (Icon Only)
Wait to Start . . . . . . . . . . . . . . . . . . . . . . (Icon Only)
NOTE: There is also an engine hour function. This
indicates the total number of hours the engine has been
running. To display the engine hours, perform the fol-
lowing: Turn the ignition switch to the RUN position, but
do not start the engine. With the odometer value dis-
played, hold the TRIP button down for a period of six
seconds. The odometer will change to trip value first,
then it will display the engine hour value. The engine
hours will be displayed for a period of 30 seconds until
the ignition switch is turned OFF or the engine is started.
15. Shift Lever Indicator
This display indicator shows the transmission shift lever
selection.
16. High Beam Indicator Light
This indicator shows that headlights are on high
beam. Push the multifunction lever forward to
switch the headlights to high beam, and pull toward
yourself (normal position) to return to low beam.
17. Voltmeter
When the engine is running, the gauge indicates the
electrical system voltage. The pointer should stay within
the normal range if the battery is charged. If the pointer
moves to either extreme left or right and remains there
during normal driving, the electrical system should be
serviced.
14 UNDERSTANDING YOUR INSTRUMENT PANEL