Dodge 2010 Ram Pickup 3500 Diesel User Manual

Page 53

transmission is sufficiently warm, will demonstrate
that the transmission is able to shift into and out of
Overdrive.

• If the vehicle has not been driven in several days, the

first few seconds of operation after shifting the trans-
mission into gear may seem sluggish. This is due to the
fluid partially draining from the torque converter into
the transmission. This condition is normal and will not
cause damage to the transmission. The torque con-
verter will refill within five seconds of shifting from
PARK into any other gear position.

Automatic Transmission with Overdrive
(AS68RC) – If Equipped (Chassis Cab Only)

The shift lever display located in the instrument panel
cluster, indicates the transmission gear range (the selector
is illuminated for night driving). The shift lever is
mounted on the right side of the steering column. You
must press the brake pedal to pull the shift lever out of

PARK position (Brake Interlock System). To drive, move
the shift lever from PARK or NEUTRAL to the desired
drive position. Pull the shift lever toward you when
shifting into REVERSE, SECOND, FIRST or PARK, or
when shifting out of PARK.

Gear Ranges
DO NOT race the engine when shifting from PARK or
NEUTRAL position into another gear range.

PARK
This range supplements the parking brake by locking the
transmission. The engine can be started in this range.
Never use PARK while the vehicle is in motion. Apply
the parking brake when leaving the vehicle in this range.
Always apply parking brake first, then place the shift
lever in PARK position. On four-wheel drive vehicles be
sure that the transfer case is in a drive position.

STARTING AND OPERATING