beautypg.com

Dodge 2011 Challenger SRT8 User Manual

Page 31

background image

• The engine can be started two consecutive times with

the RKE transmitter. However, the ignition must be
cycled by pushing the START/STOP button twice (or
the ignition switch must be cycled to the ON/RUN
position) before you can repeat the start sequence for a
third cycle.

To Exit Remote Start Mode Without Driving The
Vehicle

• Press and release the REMOTE START button one time

or allow the engine to run for the entire 15-minute
cycle.

NOTE:

To avoid unintentional shut downs, the system

will disable the one time press of the REMOTE START
button for two seconds after receiving a valid Remote
Start request.

To Exit Remote Start Mode And Drive The Vehicle
Before the end of 15 minute cycle, press and release the
UNLOCK button on the RKE transmitter to unlock the
doors and disarm the Vehicle Security Alarm (if
equipped). Then, prior to the end of the 15 minute cycle,
press and release the START/STOP button. If the
START/STOP button is not present, insert the Key Fob
into the ignition switch and turn the switch to the
ON/RUN position.

NOTE:

• For vehicles not equipped with the Keyless Enter-

N-Go feature, the ignition switch must be in the
ON/RUN position in order to drive the vehicle.

• For vehicles not equipped with the Keyless Enter-

N-Go feature, the message “Insert Key/Turn To On”
will display in the EVIC until you insert the Key Fob.
Once inserted, the message “Turn To On” will display
in the EVIC until you turn the Key Fob to ON/RUN.

2

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

29