beautypg.com

Instrument cluster descriptions – Dodge 2011 Challenger SRT8 User Manual

Page 176

background image

INSTRUMENT CLUSTER DESCRIPTIONS

1. Fuel Gauge
The pointer shows the level of fuel in the fuel tank when
the ignition switch is in the ON/RUN position.

2. Trip Odometer Button
Press this button to change the display from odometer to
either of two trip odometer settings. The letter “A” or “B”
will appear when in the trip odometer mode. Push in and
hold the button for two seconds to reset the trip odometer
to 0 miles (km). The odometer must be in TRIP mode to
reset it.

3. Speedometer
Indicates vehicle speed.

4. Electronic Speed Control Indicator Light

This light will turn on when the electronic
speed control is on.

5. Tachometer
The red segments indicate the maximum permissible
engine revolutions per minute (RPM x 1000) for each gear
range. Ease up on the accelerator before reaching the red
area.

6. Charging System Warning Light

This light shows the status of the electrical charg-
ing system. The light should turn on when the

ignition switch is first placed in ON/RUN and remain on
briefly as a bulb check. If the light stays on or turns on
while driving, turn off some of the vehicle’s non-essential
electrical devices (i.e., radio) or slightly increase engine
speed (if at idle). If the light remains on, it means that the
charging system is experiencing a problem. See your
local authorized dealer to obtain service immediately.

If jump starting is required, refer to “Jump Starting
Procedures” in “What To Do In Emergencies”.

174

UNDERSTANDING YOUR INSTRUMENT PANEL