Dodge 2012 Challenger User Manual

Page 365

WARNING!

TIREFIT is not a permanent flat tire repair. Have the
tire inspected and repaired or replaced after using
TIREFIT. Do not exceed 55 mph (88 km/h) until the
tire is repaired or replaced. Failure to follow this
warning can result in injuries that are serious or fatal
to you, your passengers, and others around you.

(E) After Driving:
Pull over to a safe location. Refer to “Whenever You Stop
to Use TIREFIT” before continuing.

1. Turn the Mode Select Knob (5) to the Air Mode
position.

2. Uncoil the power plug and insert the plug into the
vehicle’s 12 Volt power outlet.

3. Uncoil the Air Pump Hose (7) (black in color) and
screw the fitting at the end of hose (7) onto the valve
stem.

4. Check the pressure in the tire by reading the Pressure
Gauge (3).

If tire pressure is less than 19 psi (1.3 Bar)

, the tire is too

badly damaged. Do not attempt to drive the vehicle
further. Call for assistance.

If the tire pressure is 19 psi (1.3 bar) or higher:

1. Press the Power Button (4) to turn on TIREFIT and
inflate the tire to the pressure indicated on the tire and
loading information label on the driver-side door open-
ing.

NOTE:

If the tire becomes over-inflated, press the

Deflation Button to reduce the tire pressure to the recom-
mended inflation pressure before continuing.

WHAT TO DO IN EMERGENCIES

363