beautypg.com

Using homelinkĥ, Using homelink – Dodge 2012 Charger SRT8 User Manual

Page 266

background image

4. Watch for the HomeLink

௡ indicator to change flash

rates. When it changes, it is programmed. It may take up
to 30 seconds or longer in rare cases. The garage door
may open and close while you are programming.

5. Press and hold the programmed HomeLink

௡ button

and observe the indicator light.

• If the indicator light stays on constantly, program-

ming is complete and the garage door/device
should activate when the HomeLink

௡ button is

pressed.

• To program the two remaining HomeLink௡ buttons,

repeat each step for each remaining button. DO
NOT erase the channels.

If you unplugged the garage door opener/device for
programming, plug it back in at this time.

Reprogramming A Single HomeLink

Button

To reprogram a channel that has been previously trained,
follow these steps:

1. Turn the ignition switch to the ON/RUN position.

2. Press and hold the desired HomeLink

௡ button until

the indicator light begins to flash after 20 seconds. Do not
release the button.

3. Without

releasing

the

button

proceed

with

“Canadian/Gate Operator Programming” Step 2 and
follow all remaining steps.

Using HomeLink

To operate, press and release the programmed
HomeLink

௡ button. Activation will now occur for the

programmed device (i.e., garage door opener, gate opera-
tor, security system, entry door lock, home/office light-
ing, etc.,). The hand-held transmitter of the device may
also be used at any time.

264

UNDERSTANDING THE FEATURES OF YOUR VEHICLE