beautypg.com

Dodge 2012 Ram Diesel User Manual

Page 41

background image

“Electronic Vehicle Information Center (EVIC)” in “Un-
derstanding Your Instrument Panel” for further informa-
tion. When engine temperatures fall below 66°F (19°C)
the “Wait To Start Light” will remain on indicating the
intake manifold heater system is active.

Follow the steps in the “Normal Starting” procedure
except:

1. The “Wait To Start Light” will remain on for a period
of time (length of time depends on engine temperature).

CAUTION!

If the “Water in Fuel Indicator Light” remains on, DO
NOT START engine before you drain the water from
the fuel filter to avoid engine damage. Refer to
“Maintenance Procedures/Draining Fuel/Water Sepa-
rator Filter” in “Maintaining Your Vehicle” for fur-
ther information.

2. After the “Wait To Start Light” goes off, turn the
ignition switch to the START position. Do not press the
accelerator during starting.

CAUTION!

Do not crank engine for more than 15 seconds at a
time or starter motor damage may result. Turn the
ignition switch to the OFF position and wait at least
two minutes for the starter to cool before repeating
start procedure.

3. After engine start-up, check to see that there is oil
pressure.

4. Allow the engine to idle about three minutes until the
manifold heaters have completed the post-heat cycle.

5. Release the parking brake and drive.

4

STARTING AND OPERATING

39